Fittings and adapters
10 kL hot-water tank - 90 degree low DN80 side outlet
- Bounding box
- 2720.0 × 2620.0 × 3079.2 mm
- Engine
- Precision B-rep
- Parameters
- 19
- Published
- November 4, 2026
Download
Free to download and use. See the terms.
The prompt
Corrected 10 kL tank: two DN50 CHP and heat-pump sidewall inlets 180 degrees apart near the top, and one DN80 low-level sidewall outlet at 90 degrees to both, centre 100 mm above inner floor. Tank bottom remains closed; reinforced low-side nozzle, flange and stands are separate editable CAD parts.
Parameters
| Name | Value | Range |
|---|---|---|
| Internal tank capacity | 10000 L | 6000 – 20000 |
| Tank internal diameter | 2300 mm | 1800 – 3000 |
| Cylindrical shell thickness | 8 mm | 5 – 16 |
| Bottom plate thickness | 10 mm | 6 – 20 |
| Roof plate thickness | 8 mm | 5 – 16 |
| Tank bottom elevation | 650 mm | 450 – 900 |
| Square support leg size | 130 mm | 100 – 180 |
| Square support footplate | 230 mm | 175 – 300 |
| Inlet axis below internal roof | 300 mm | 150 – 700 |
| DN50 nozzle projection | 180 mm | 100 – 350 |
| DN80 radial nozzle projection | 260 mm | 100 – 350 |
| Outlet centre height above inside bottom | 100 mm | 80 – 450 |
| DN50 pipe outside diameter | 60.3 mm | 58 – 65 |
| DN50 pipe bore | 52.5 mm | 45 – 56 |
| DN80 pipe outside diameter | 88.9 mm | 86 – 95 |
| DN80 pipe bore | 77.9 mm | 69 – 83 |
| DN50 Class 150 flange OD | 152.4 mm | 145 – 170 |
| DN80 Class 150 flange OD | 190.5 mm | 180 – 210 |
| Nozzle flange thickness | 22 mm | 18 – 30 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →SM1 to RMS Thread Adapter
thorlabs SM1A3 adapter has external SM1 (1.035"-40) threading and internal RMS (0.800"-36) threading.
Cylindrical D-Shaft Flange
Create a cylindrical flange with a base diameter of 40 mm and a total height of 15 mm. Feature an 8 mm central D-shaft bore through the entire height. On the bottom 4 mm thick flan
Temperature Controller Case with Power Adapter End
resize to fit a temperature controller measuring 110 × 70 × 35 mm, add a end to fit a circled power adapter
Shouldered Spacer 20/26 x 15
Create a mechanical shouldered spacer from scratch. Main body: 20 mm outer diameter and 12 mm height. Add a concentric flange at the bottom: 26 mm outer diameter and 3 mm thickness
90 Degree Elbow with Perpendicular Cross Holes
elbow 90 degree to it with a length one side 20 other side 30 width 20 and on both sides in the center a perpendicular hole to it.
D120 Flange
make flange of diameter 120mm with 10mm thickness