Mechanical parts
Utility Trailer with Drop‑Down Sides and Tailgate
- Bounding box
- 4802.9 × 2500.1 × 1140.0 mm
- Engine
- Precision B-rep
- Parameters
- 19
- Published
- November 2, 2026
Download
Free to download and use. See the terms.
The prompt
Please design a utility trailer with drop down sides and tail gate. The trailer should have a load bed length of 3.6m and a load bed width of 1.8 m. It should have braked tandem axles. The load bearing capacity should be 2000kg. The sides should be 70 cm high. It should have 15" wheels. There should be 4 parking jackseach with 900 kg load capacity, to allow the load to be stored over extended periods of time.
Parameters
| Name | Value | Range |
|---|---|---|
| Bed Length | 3600 mm | 3000 – 5000 |
| Bed Width | 1800 mm | 1500 – 2200 |
| Frame Thickness | 40 mm | 20 – 80 |
| Side Panel Height | 700 mm | 500 – 1000 |
| Side Panel Thickness | 30 mm | 15 – 60 |
| Tailgate Width | 1800 mm | 1500 – 2200 |
| Tailgate Height | 700 mm | 500 – 1000 |
| Tailgate Thickness | 30 mm | 15 – 60 |
| Wheel Diameter (15") | 381 mm | 300 – 450 |
| Wheel Width | 200 mm | 100 – 300 |
| Wheel Inner Offset | 150 mm | 100 – 250 |
| Axle Beam Diameter | 50 mm | 30 – 100 |
| Front Axle Offset from Front Edge | 900 mm | 500 – 1500 |
| Rear Axle Offset from Rear Edge | 900 mm | 500 – 1500 |
| Parking Jack Height (ground to frame) | 400 mm | 300 – 700 |
| Parking Jack Diameter | 60 mm | 40 – 100 |
| Hitch Forward Length | 1000 mm | 500 – 1500 |
| Hitch Beam Width | 40 mm | 30 – 80 |
| Hitch Beam Height | 60 mm | 40 – 100 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.