Mechanical parts
TILT-X1 H-Tail with Servo Mounts and Pushrod Routes
- Bounding box
- 100 × 408 × 140.0 mm
- Engine
- 3D Printing B-rep
- Parameters
- 3
- Published
- November 5, 2026
Download
Free to download and use. See the terms.
The prompt
TILT-X1 H-tail revision: elevator servo pockets in the stabilizers with arm slots, rudder servo pockets open to the outer fin face at horn height, thicker stabilizer, same hinges and dowel joints.
Parameters
| Name | Value | Range |
|---|---|---|
| Stabilizer thickness ratio (servo pocket needs about 0.17 or more) | 0.18 mm | 0.15 – 0.2 |
| Gap between hinge knuckles | 0.5 mm | 0.3 – 0.9 |
| Hinge pin hole for 1.75 mm filament | 2 mm | 1.8 – 2.4 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.