Mechanical parts
Tesla D-Valve Flow Channel (2D Profile)
- Bounding box
- 75.3 × 48.4 × 1.0 mm
- Engine
- Precision B-rep
- Parameters
- 15
- Published
- September 22, 2026
Download
Free to download and use. See the terms.
The prompt
Create a 2D sketch on the XY plane for a Tesla D-valve flow channel. The main channel width is W = 2 mm. The inlet straight section length L1 = 10 mm. Junction connector length L2 = 2 mm. Main channel length L5 = 24.65 mm. Main radius R = 22 mm. Small arc at junction 1 ra = 2.5 mm with angle 33 degrees. Inner loop arc rb = 4 mm with angle 243.5 degrees. Side channel bend rc = 2 mm with angle 75 degrees. Side channel upper arm L3 = 8.75 mm, lower arm L4 = 7.85 mm. Outlet straight section length L6 = 50 mm. Combine into a continuous 2D planar face profile for fluid domain modeling.
Parameters
| Name | Value | Range |
|---|---|---|
| Channel Width W | 2 mm | 0.5 – 6 |
| Inlet Straight L1 | 10 mm | 2 – 40 |
| Junction Connector L2 | 2 mm | 0.5 – 10 |
| Outlet Straight L6 | 50 mm | 5 – 120 |
| Main Channel Length L5 | 24.65 mm | 5 – 60 |
| Main Channel Radius R | 22 mm | 10 – 60 |
| Junction Arc ra | 2.5 mm | 0.5 – 8 |
| Junction Arc Angle | 33 deg | 5 – 90 |
| Inner Loop Arc rb | 4 mm | 1 – 15 |
| Inner Loop Angle | 243.5 deg | 90 – 330 |
| Side Bend rc | 2 mm | 0.5 – 8 |
| Side Bend Angle | 75 deg | 10 – 150 |
| Upper Arm L3 | 8.75 mm | 1 – 30 |
| Lower Arm L4 | 7.85 mm | 1 – 30 |
| Sketch Extrusion Thickness | 1 mm | 0.2 – 5 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.