Mechanical parts
Servo Pushrod Clevis
- Bounding box
- 35.0 × 10.0 × 8.0 mm
- Engine
- Precision B-rep
- Parameters
- 12
- Published
- October 24, 2026
Download
Free to download and use. See the terms.
The prompt
A servo pushrod connector clevis. Main body: a rectangular block 25mm long × 10mm wide × 8mm thick. At one end: a clevis fork — two parallel prongs extending 10mm, each 3mm thick, spaced 6mm apart internally. Each prong has a 2mm diameter hole, aligned, for a pivot pin. At the opposite end: a 4mm diameter threaded hole, 12mm deep, centered — for attaching a threaded pushrod (M4 threaded rod). A 3mm diameter cross-hole through the block, 8mm from the threaded end, for a set screw to lock the pushrod. All edges: 0.3mm chamfer. Material: PETG or PLA.
Parameters
| Name | Value | Range |
|---|---|---|
| Body Length | 25 mm | 10 – 60 |
| Body Width | 10 mm | 6 – 32 |
| Body Thickness | 8 mm | 4 – 25 |
| Prong Length | 10 mm | 4 – 30 |
| Fork Gap (internal) | 6 mm | 1 – 12 |
| Pivot Pin Hole Ø | 2 mm | 0.5 – 6 |
| Pin Hole Center from Fork Shoulder | 6 mm | 1 – 25 |
| Pushrod Bore Ø (M4 nominal) | 4 mm | 1.5 – 12 |
| Pushrod Bore Depth | 12 mm | 3 – 50 |
| Set Screw Cross-Hole Ø | 3 mm | 1 – 8 |
| Cross-Hole from Threaded End | 8 mm | 2 – 50 |
| Edge Chamfer | 0.3 mm | 0 – 1.5 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.