Puck with Silicone Insert

create a cylindrical puck with a 50mm outer diameter and 16mm height. On the tio surface, create a shallow concave rim defined by a 40mm diameter spherical cap that is 6mm deep at its lowest point. This concave geometry should only form the outer ring of the puck. Inside this rim, model a separate silicone insert body that sits inside the concave rim but has a completely flat top surface. The silicone insert should be 2mm thick and follow the rim only at its edges, not in its top surface. In the center of the flat silicone insert, create a circular ring cavity 22mm in diameter and 8mm deep. the cavity should begin at the flat silicone surface and extend downward, passing below the depth of the concave rim. allow the ring cavity to cut through the lowest point of the spherical bowl while preserving the curved rim geometry. maintain atleast 10mm of solid material beneath the ring cavity to allow space for future sensor placement. Do not model any sensors or electronics at this stage

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.