Mechanical parts
Precision Cue Tip and Threaded Ferrule
- Bounding box
- 13.4 × 13.4 × 79.0 mm
- Engine
- 3D Printing B-rep
- Parameters
- 18
- Published
- November 17, 2026
Download
Free to download and use. See the terms.
The prompt
Ferrule with screwed bolt and tip
Parameters
| Name | Value | Range |
|---|---|---|
| Shaft diameter at the joint | 12.75 mm | 9 – 14 |
| Shaft stub length | 60 mm | 20 – 150 |
| Extra diameter at the butt end of the stub | 0.6 mm | 0 – 3 |
| Threaded stud (bolt) diameter | 9.5 mm | 6 – 12 |
| Stud length | 12 mm | 6 – 25 |
| Thread pitch | 1.5 mm | 0.8 – 3 |
| Thread radial depth | 0.6 mm | 0.3 – 1 |
| Thread ridge width | 0.5 mm | 0.25 – 1 |
| Threaded engagement length | 10 mm | 4 – 25 |
| Ferrule length | 14 mm | 6 – 30 |
| Edge chamfer | 0.6 mm | 0 – 1.5 |
| Top groove offset below the crown | 2.5 mm | 0.5 – 8 |
| Groove width | 1 mm | 0.6 – 2 |
| Groove depth | 0.4 mm | 0.2 – 1 |
| Tip thickness | 6 mm | 3 – 12 |
| Crown height | 0.9 mm | 0 – 2.5 |
| Radius inset from the ferrule OD | 0.2 mm | 0 – 1 |
| Sliding clearance per side | 0.2 mm | 0.1 – 0.4 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.
