Mechanical parts
Platform with legs, Velcro slots, and rear extension
- Bounding box
- 248.0 × 149.0 × 15.0 mm
- Engine
- Precision B-rep
- Parameters
- 16
- Published
- October 8, 2026
Download
Free to download and use. See the terms.
The prompt
a platform 172mm wide x 90mm long. with 4 legs 10mm long they should be 15mm from the corners and perfect for m3 screws.platform is 5mm thick. looking at the platform like a car on the right side make 2 slots for Velcro straps that are 50mm apart the slots need to run front to back and start the first one 6mm from the side. then measure the 50mm from the same side. the slots should be centered front to back also.we need to extend the rear of the platform 14mm long starting 15mm from each side. please round the inside corners.
Parameters
| Name | Value | Range |
|---|---|---|
| Platform Width | 172 mm | 100 – 300 |
| Platform Length | 90 mm | 50 – 200 |
| Platform Thickness | 5 mm | 2 – 10 |
| Rear Extension Length | 14 mm | 5 – 40 |
| Rear Extension Inset | 15 mm | 0 – 50 |
| Rear Inside Corner Fillet | 2 mm | 0.5 – 4 |
| Leg Length | 10 mm | 5 – 30 |
| Leg Diameter | 10 mm | 6 – 20 |
| Leg Inset X | 15 mm | 5 – 50 |
| Leg Inset Y | 15 mm | 5 – 50 |
| M3 Clearance Hole Diameter | 3.2 mm | 2.5 – 5 |
| Slot Count | 2 mm | 1 – 4 |
| First Slot Offset From Right | 6 mm | 2 – 60 |
| Slot Spacing | 50 mm | 10 – 150 |
| Slot Width | 3 mm | 1 – 10 |
| Slot Length | 20 mm | 5 – 80 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.