Open-Top Electronics Enclosure

A 3D-printable rectangular electronics enclosure box without a lid, outer dimensions 115 mm length (X-axis), 80 mm width (Y-axis), and 36 mm height (Z-axis), with a uniform wall thickness of 2.5 mm and a 2.5 mm thick flat bottom floor. Add 3 mm outer corner fillets on the vertical edges. In each of the four inner corners, add a vertical cylindrical mounting boss 6 mm in diameter, extending from the floor up to 34 mm height, each with a 2.5 mm through-hole for M3 lid screws. On the inner floor, add three sets of cylindrical PCB screw standoffs (4.5 mm outer diameter, 1.7 mm inner pilot hole for M2 self-tapping screws, 4 mm height): Set 1 (ESP32-C3 clamp mounts) centered near the left wall (X=14 mm, Y=40 mm) with two standoffs spaced 20 mm apart along the Y-axis to clamp the side edges of an 18 mm x 22.5 mm microcontroller board using screw heads; Set 2 (JSN-SR04T ultrasonic module) in the back-right area with four standoffs arranged in a 37 mm x 22 mm rectangle; Set 3 (LR7843 MOSFET module) in the front-right area with four standoffs arranged in a 28 mm x 12 mm rectangle. Cut four openings in the walls: (1) on the left wall (X=0), centered at Y=40 mm, a rounded rectangular cutout 9.5 mm wide by 5 mm high with its bottom edge at Z=6.5 mm (aligned with the 4 mm standoff height) for a USB-C connector; (2) on the right wall (X=115), a 6.5 mm circular hole at Y=60 mm, Z=12 mm for the ultrasonic sensor cable; (3) on the right wall (X=115), a 12 mm wide by 10 mm high rectangular cutout at Y=35 mm, Z=12 mm for a panel-mount DC power connector; (4) on the right wall (X=115), a 6 mm circular hole at Y=15 mm, Z=12 mm for the water pump power cable. Add two small U-shaped cable tie loops (4 mm inner width, 2 mm thick) on the inner floor 10 mm away from the right wall cutouts for strain relief. Clean manifold geometry optimized for FDM 3D printing.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.