F-150 Raptor Console T-Insert

Design a precision-fit, T-profile 3D printing insert for the narrow center console slot of a 2025 Ford F-150 Raptor. CRITICAL LAYOUT & GEOMETRY RULES: - The part consists of two joined solid sections: a narrow LOWER WEDGE STEM that drops into the factory console slit, and a wider UPPER MOUNTING DECK that rests flat on top of the console trim bezel. - All three mounting holes MUST be arranged in a SINGLE STRAIGHT LINE along the X-axis (Y = 0 for all three holes). 1. Lower Wedge Stem (Fits inside the 16.80mm x 211.1mm console slot with ~0.65mm perimeter clearance for foam tape): - Top cross-section (at Z = 0mm, meeting the underside of the upper deck): 209.5mm length (X-axis, spanning from X = -104.75mm to X = +104.75mm) x 15.5mm width (Y-axis). - Bottom cross-section (at Z = -32mm, resting on the bottom rubber mat): 190.0mm length (X-axis, spanning from X = -91.0mm to X = +99.0mm) x 13.0mm width (Y-axis). - Asymmetric End Taper: The left end wall (front, near X = -104.75mm) slopes inward by 13.75mm over the 32mm depth (~23-degree ramp), while the right end wall (rear, near X = +104.75mm) tapers inward by only 5.75mm (~10-degree near-vertical wall). - Corner radius: 4mm vertical corner radius on all four corners of the stem. 2. Upper Mounting Deck (Rests flush on top of the console bezel from Z = 0mm to Z = +12mm): - Dimensions: 214mm length (X-axis) x 38mm width (Y-axis) x 12mm height (Z-axis), centered over the lower stem. - Edge finishing: 2mm fillet around all top outer edges and vertical corners. 3. Three Inline Mounting Holes (Centered on Y = 0, spaced evenly along X): - Hole positions: X = -65mm, X = 0mm, and X = +65mm (all at Y = 0mm). - Hole dimensions (sized for 1/4"-20 or M5 brass heat-set inserts): Upper bore of 8.0mm diameter x 10mm deep from the top surface (Z = +12mm down to Z = +2mm), continuing as a 6.5mm diameter through-hole down to Z = -10mm into the stem. 4. Output Format: - Single solid, watertight manifold body in millimetres, ready for STL export.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.