Mechanical parts
Egg Cracker & Strainer
- Bounding box
- 69.3 × 54.0 × 68.2 mm
- Engine
- 3D Printing B-rep
- Parameters
- 12
- Published
- November 5, 2026
Download
Free to download and use. See the terms.
The prompt
no no no, can you redesign it I need it to look like an egg and then when you insert the egg in it it will close then there are 2 sharp things on the side attached to a spring so it can go inside and then break the egg so when you pull it apart then only the egg will come out
Parameters
| Name | Value | Range |
|---|---|---|
| Top flat diameter | 16 mm | 8 – 60 |
| Egg height | 70 mm | 40 – 140 |
| Egg widest diameter | 54 mm | 30 – 160 |
| Shell wall thickness | 2.5 mm | 1.2 – 5 |
| Split line height | 32 mm | 15 – 100 |
| Slot width | 2 mm | 1.5 – 3.5 |
| Slot length | 12 mm | 6 – 20 |
| Number of slots | 20 mm | 12 – 48 |
| Downward tilt of spike | 25 deg | 10 – 60 |
| Spike assembly length | 26 mm | 16 – 45 |
| Spring coil diameter | 12 mm | 7 – 20 |
| Spike shaft diameter | 4 mm | 3 – 8 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
Nuclear Medicine Center Functional Floor Plan (Parametric Wall Model)
Create a **2D architectural floor plan in DWG format** for a new **Nuclear Medicine Center**. This is a **generic conceptual functional layout**, NOT a construction-ready project.