Jigs and fixtures
Barcode Scanner Stand
- Bounding box
- 110 × 130 × 209.1 mm
- Engine
- 3D Printing B-rep
- Parameters
- 19
- Published
- November 22, 2026
Download
Free to download and use. See the terms.
The prompt
Create a modern, sleek desktop barcode camera scanner stand for 3D printing. Include a wide rounded-rectangle weighted base (110mm wide, 130mm deep, 12mm thick) with 5mm filleted edges. From the back of the base, extend a curved ergonomic neck rising 160mm high and angling forward at 15 degrees. At the top of the neck, attach a smooth rounded rectangular camera head (54mm wide, 54mm deep, 32mm high) tilted downward at 35 degrees toward the front of the base. Hollow out the inside of the camera head (42mm x 42mm x 26mm) leaving the back open, add a 22mm circular lens cutout centered on the front face, and add a 10mm x 8mm rear cable slot at the bottom of the head.
Parameters
| Name | Value | Range |
|---|---|---|
| Base width | 110 mm | 60 – 200 |
| Base depth | 130 mm | 60 – 220 |
| Base thickness | 12 mm | 6 – 30 |
| Base corner radius | 5 mm | 1 – 20 |
| Neck height | 160 mm | 80 – 250 |
| Neck forward lean | 15 deg | 0 – 35 |
| Neck width | 28 mm | 16 – 60 |
| Neck thickness | 14 mm | 8 – 30 |
| Head width | 54 mm | 30 – 100 |
| Head depth | 54 mm | 30 – 100 |
| Head height | 32 mm | 20 – 70 |
| Head downward tilt | 35 deg | 0 – 60 |
| Head corner radius | 4 mm | 1 – 10 |
| Cavity width | 42 mm | 20 – 90 |
| Cavity depth | 42 mm | 20 – 90 |
| Cavity height | 26 mm | 10 – 60 |
| Lens hole diameter | 22 mm | 8 – 40 |
| Cable slot width | 10 mm | 4 – 30 |
| Cable slot depth | 8 mm | 3 – 30 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →M5 Hex Bolt and Nut Assembly
Create a precise, editable, parametric mechanical CAD assembly based on the provided engineering drawing reference. UNIT SYSTEM: Use millimeters (mm). Model all dimensions exactl
Six-Canister Film Tray
Create a tray for six 35 mm film canisters with transport handles
Washbasin Stand
Create a welded stainless-steel washbasin stand made from rectangular hollow sections 40 × 60 × 3 mm. The stand consists of two parallel vertical rectangular side frames facing ea
Linear Tray
// Linear tray 200x75x15 mm. Print flat, no supports. $fn=64; N=10; e=0.01; L=200; W=75; R=12; bt=5; wt=5; H=15; ri=R-wt; rt=2.4; ff=1; ch=0.6; module rr(l,w,r) offset(r=r) square
Skew Planar Antenna Bending Jig
Create a jig for the skew planar antenna 4 lobs banding at 43 angle.
Go-Kart Steering Rack Assembly
simple ultra compact lightwweight cheap steering rack for a go kart vehicue
