Washbasin Stand

Create a welded stainless-steel washbasin stand made from rectangular hollow sections 40 × 60 × 3 mm. The stand consists of two parallel vertical rectangular side frames facing each other, like two table legs. Their bottom edges are at the same elevation. Frame A has an overall height of 755 mm and an overall depth of 340 mm. Frame B has an overall height of 650 mm and an overall depth of 340 mm. Both frames must have exactly the same depth of 340 mm. The clear horizontal distance between the inner faces of Frame A and Frame B is 640 mm. Connect the two frames with two horizontal RHS members positioned at the rear side of the stand. The lower connecting member is located completely at the bottom. The upper connecting member has its upper edge 200 mm below the top edge of the shorter frame. All corners of both rectangular frames must use clean 45-degree miter joints. Use neat, ground and polished welds suitable for a visible design product. Close all open tube ends. Produce an editable, dimensionally accurate parametric CAD model. Also produce an isometric view, front view, side view and top view. Do not alter or approximate any dimensions.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.