10.0140.010.0
Loading the interactive model…
Interactive 3D model of Wooden-style Ballpoint Pen

Brackets and mounts

Wooden-style Ballpoint Pen

3 views
Bounding box
140.0 × 10.0 × 10.0 mm
Engine
Precision B-rep
Parameters
11
Published
November 18, 2026

Download

Free to download and use. See the terms.

The prompt

Create a precise 3D model of a wooden-style ballpoint pen based on the attached reference photograph. The pen should have a simple, elegant cylindrical design with no clip. Exact dimensions: * Total length: 140 mm * Main cylindrical body: 114 mm long, 10 mm diameter * Rear end cap: 9 mm long, 7 mm diameter * Front tapered section: 16 mm long, gradually narrowing from the 10 mm body diameter to the tip * Pen tip: 1 mm long * Total front assembly: 17 mm Shape and design details: 1. The main body must be a perfectly straight cylinder with a diameter of 10 mm and a length of 114 mm. 2. The rear end cap must be located at the back of the pen, measuring 9 mm long and 7 mm in diameter. It should connect smoothly to the main body. 3. The front section must gradually taper from the main body’s 10 mm diameter into a narrow pointed pen tip. The transition should be smooth and natural, without a sudden step or sharp shoulder. 4. The pen tip should be very small, measuring 1 mm in length, and seamlessly connected to the tapered front section. 5. Remove the clip completely. There must be no clip, attachment, ornament, hole, or extra protrusion on the pen body. 6. Keep the entire pen symmetrical along its central longitudinal axis. 7. The design should resemble the wooden pen in the reference photo, with a minimal, smooth, rounded cylindrical appearance. 3D modeling requirements: * Create a single solid, watertight, manifold 3D printable model. * No floating parts or disconnected geometry. * Smooth transitions between all connected sections. * No textures, colors, wood grain, or decorative lettering. * Ensure the overall length is exactly 140 mm. * Ensure the main body diameter is exactly 10 mm. * Optimize the model for FDM 3D printing. * Export as an STL file. Create the model with accurate dimensions rather than a merely visual approximation. Use millimeters as the unit system.

Parameters

NameValueRange
Total Length140 mm100 – 220
Body Length114 mm60 – 180
Body Diameter10 mm6 – 20
Rear Cap Length9 mm3 – 25
Rear Cap Diameter7 mm3 – 12
Front Taper Length16 mm5 – 40
Tip Length1 mm0.2 – 6
Tip Diameter1 mm0.2 – 4
Cap-to-Body Fillet0.8 mm0 – 1.2
Rear Edge Fillet0.5 mm0 – 1.5
Tip Edge Fillet0.3 mm0 – 0.5

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.