Brackets and mounts
WearCare Small TP4056 PCB Cover Only
- Bounding box
- 28.0 × 19.0 × 2.7 mm
- Engine
- Precision B-rep
- Parameters
- 9
- Published
- November 3, 2026
Download
Free to download and use. See the terms.
The prompt
Only a small removable protective cover for TP4056 on WearCare2(2).step. The attached STEP model was measured: TP4056 board envelope is approximately 26x17 mm, centered at X=-20, Y=-13.5; support pad approximately 27x18 mm, same center. Cover is 28x19 mm, not a full enclosure cover. Positioned at Z=5.9 mm to sit above the charger envelope (which extends to about Z=5.6 mm) and below the rim. Four short retaining corner clips are used, leaving sides open for wires/airflow. Exact top-shell clearance and fit still require FreeCAD check.
Parameters
| Name | Value | Range |
|---|---|---|
| Cover length | 28 mm | 27 – 32 |
| Cover width | 19 mm | 18 – 23 |
| Plate thickness | 1.5 mm | 1.2 – 2 |
| Center X | -20 mm | -22 – -18 |
| Center Y | -13.5 mm | -15 – -12 |
| Plate underside Z | 5.9 mm | 5.7 – 6.5 |
| Clip thickness | 0.9 mm | 0.7 – 1.2 |
| Clip height | 1.2 mm | 0.8 – 1.8 |
| Corner radius | 1 mm | 0.5 – 1.5 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
Kugoo G2 Pro Rear Swingarm for KuKirin G4
Create a detailed 1:1 CAD drawing of custom rear swingarms for the Kugoo G2 Pro 2020 electric scooter. The swingarms must be designed to fit a KuKirin G4 hub motor instead of the o