Water Drip Tray Over Server Cabinet

General Specification (ข้อกำหนดทั่วไปของวัสดุ) • Material: Fabricated from Galvanized Steel (Thickness ≥ 1.2 mm) or Stainless Steel. • Edge Height: The tray wall edge height must be ≥ 50 mm to prevent overflow. • Support System: Suspended from the ceiling structure using heavy-duty Threaded Rods with matching Brackets/Anchors. • Drainage: Equipped with a 1” to 1-½” drain outlet connected to a dedicated Drain Pipe routing down to the nearest floor drain. 1. Front / Section View Details (ดีเทลระดับและความสูง) • Clearance Above Cabinet: Maintain a minimum vertical clearance of ≥ 100 mm between the top of the cabinet and the bottom of the water drip tray. • Tray Alignment: The water drip tray must completely cover the top area of the cabinet, ensuring the tray edges extend ≥ 50 mm beyond the cabinet’s physical perimeter to capture any overhead dripping. • Leveling & Slope: The tray must be installed with a continuous downward slope of 1% to 2% directed toward the drainage point to ensure absolute water flow and prevent stagnant accumulation. 2. Top View Details (ดีเทลระนาบและการจัดวางท่อ) • Coverage & Orientation: Position the water drip tray directly aligned over the center mass of the electrical/server cabinet group. • Drain Position: Locate the drain outlet at the lowest corner of the tray slope, away from any electrical cable entry points. • Support Layout: Distribute the ceiling-mounted threaded rods uniformly at the designated hanging points to balance the total weight of the tray when filled with water. 3. Side View Details (ดีเทลมุมมองด้านข้างและการเดินท่อ) • Drain Pipe Installation: Secure the 1” – 1-½” drain pipe vertically against the wall or structural columns using rigid pipe clamps/straps. • Drop Profile: Ensure the drain pipe runs straight down to the floor drain with minimal bends to maximize gravity discharge. • Rod Rigidity: Check the plumbness (vertical alignment) of the threaded rods from the side profile to ensure the tray does not sway or shift during operation. 4. Isometric / 3D Assembly View Details (ดีเทลภาพรวมและการประกอบ) • Overhead System Integrity: The entire assembly (Threaded Rods + Drip Tray + Drainage Network) must be securely locked with double nuts/washers at every connection point to resist vibration. • Water Tightness: All welded joints on the tray perimeter and around the drain nozzle must be 100% water-tight and treated with anti-corrosion coating (if using galvanized steel).

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.