Mechanical parts
Wall-mounted monstrance holy water font
- Bounding box
- 63.5 × 34.8 × 109.2 mm
- Engine
- 3D Printing B-rep
- Parameters
- 2
- Published
- November 20, 2026
Download
Free to download and use. See the terms.
The prompt
Create this font with the monstrance, with a screw hole behind the host in the center and a completely flat backside aside from the screw hole.
Parameters
| Name | Value | Range |
|---|---|---|
| Screw head entry diameter | 8.2 mm | 7 – 8.6 |
| Screw shank slot width | 4.2 mm | 3.4 – 4.6 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →SWYFT Reference-Style 3.5 inch Mold 16mm
One-piece open casting mold following the user's uploaded SWYFT wheel design brief. Outside diameter including rounded tabs: 88.9 mm. Cavity thickness: 16 mm. 12 curved spokes. Cir
Stepped Shaft with Keyway
Create a stepped cylindrical shaft in C45 steel, length 120 mm, diameter 30 mm, featuring an 8x7 mm parallel keyway slot."
Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
Two-Joint Robotic Arm with Parallel Gripper
i want a 2 joint robotic arm with parallel gripper simple design. Servo-Base: smart/serial-bus servo, true 360° positional control. Turret rides on a bearing so the servo only driv
