Two-Part Utensil Drawer Organizer

Create a rectangular organizer consisting of two sections, each measuring **250 mm long × 245 mm wide × 76 mm high** when assembled. The sections must join end-to-end, producing a finished organizer measuring 500 × 245 × 76 mm, including all joints and external walls. ### STL File 1 — Utensil Section A Dimensions: 250 × 245 × 76 mm. - Rectangular tray with a solid, flat bottom. - Four equally sized, parallel utensil compartments running lengthwise. - Three internal divider walls. - External walls on the two long sides and one short end. - The opposite short end must remain open to connect to Section B. - Internal divider walls must extend to the open end. - Use approximately 2.4 mm wall thickness. - Use approximately 2.4 mm floor thickness. - All walls must be printable vertically without supports. ### STL File 2 — Utensil Section B + Open Compartment C Overall dimensions: 250 × 245 × 76 mm. Section B: - Occupies the first 125 mm of length. - Continues the four utensil compartments from Section A. - Contains three internal divider walls aligned precisely with those in Section A. - The connecting short end must remain open. Section C: - Occupies the final 125 mm of length. - Contains one full-width open compartment. - A full-width transverse partition wall separates B from C. - The far short end must have an external wall. ### Joining system - Design a simple, removable, interlocking joint between A and B. - Prefer low-profile alignment tabs and matching sockets beneath the tray or integrated into the floor. - Do not require screws, glue, magnets, or purchased hardware. - Use approximately 0.25 mm clearance between mating surfaces. - All joints must fit within the specified 250 mm length of each piece. - The assembled sections must sit flat on the drawer bottom. - Do not add a full-height wall at the A/B seam. - The four utensil channels must remain open and continuous across the seam. - No joints may protrude beyond the overall assembled dimensions. ### Printability requirements - Both STL files must fit individually within a 256 × 256 mm build area. - Print flat with the open tray facing upward. - No supports required. - Suitable for standard PLA or PLA+ with a 0.4 mm nozzle. - No floating geometry, non-manifold edges, or disconnected pieces. - Slightly round exposed corners and top edges for easier cleaning. - Keep the bottom flat and avoid unnecessary solid infill. - Minimize filament usage without compromising normal household durability.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.