Brackets and mounts
Tripod C-frame gimbal v2 (tilt axis along arm)
- Bounding box
- 718.2 × 630.0 × 1188.0 mm
- Engine
- Precision B-rep
- Parameters
- 20
- Published
- November 17, 2026
Download
Free to download and use. See the terms.
The prompt
Tripod C-frame pan-tilt gimbal, no gun, revised so the tilt axis runs along the arm: single tilt drum on the front face of the upright, gray mount plate on the drum, payload deck with side ribs extending forward, sensor pod on deck.
Parameters
| Name | Value | Range |
|---|---|---|
| Tripod hub height | 650 mm | 400 – 900 |
| Leg foot radius | 380 mm | 250 – 550 |
| Leg diameter | 25 mm | 15 – 40 |
| Tripod hub diameter | 90 mm | 60 – 130 |
| Pan base diameter | 170 mm | 120 – 240 |
| Pan base height | 90 mm | 50 – 140 |
| Body width | 130 mm | 100 – 180 |
| Lower arm overhang | 85 mm | 40 – 140 |
| Upright rear face X | 150 mm | 100 – 220 |
| Upright thickness | 90 mm | 60 – 130 |
| Upright height | 330 mm | 250 – 420 |
| Lower block height | 110 mm | 70 – 160 |
| Tilt axis below upright top | 50 mm | 30 – 90 |
| Tilt drum diameter | 100 mm | 60 – 120 |
| Payload arm length | 340 mm | 200 – 450 |
| Mount plate height | 140 mm | 100 – 200 |
| Plate thickness | 8 mm | 5 – 14 |
| Pod length | 150 mm | 100 – 220 |
| Pod width | 110 mm | 70 – 120 |
| Pod height | 90 mm | 50 – 130 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
JZX100 Gas Cap Holder
can you make a gas cap holder for a jzx100 chaser. i want you to refer to the image and make a cad very close to the picture
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
