touch switch cover

Create a single solid part called "touch switch cover". Units: millimeters. 1. Make a rectangular block 90 wide in X, 125 tall in Y, 9 deep in Z, centered on the origin in X and Y, extending from Z=0 (front face) to Z=9 (back face). 2. Round the four edges parallel to Z with radius 6. Fillet the outer edge of the front face (Z=0) with radius 1.5. 3. Hollow it from the back: cut a rectangular pocket 86 in X by 121 in Y with corner radius 4, starting at the back face Z=9 and going to Z=2. This leaves a 2 mm front wall and 2 mm side walls. 4. Add four solid cylinders, diameter 10, centered at (37,54.5), (-37,54.5), (37,-54.5), (-37,-54.5), each extending from Z=2 to Z=5.5 and merged with the front wall and side walls. 5. In the back end (Z=5.5) of each cylinder, cut a hole diameter 6.2 and depth 2.2 (to Z=3.3) for magnets. 6. On the inside of the front wall, cut two rectangular pockets, each 15.6 wide in X and 11.6 tall in Y, from Z=2 toward the front to Z=1, centered at (-22.5, 0) and (22.5, 0). The remaining front skin there is 1.0 thick. 7. On the front face (Z=0), engrave two ring grooves 0.4 deep, centered at (-22.5, 0) and (22.5, 0), outer diameter 20, inner diameter 18. 8. On the front face, engrave a straight groove 0.8 wide and 0.4 deep along the Y axis at X=0, from Y=-30 to Y=30. 9. On the bottom side wall (the wall at Y=-62.5), cut a notch at the back edge: 12 wide in X, through the wall thickness in Y, from Z=7.5 to Z=9.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.