60.4216136
Loading the interactive model…
Interactive 3D model of Tesla Model Y Style Mirror Housing

Brackets and mounts

Tesla Model Y Style Mirror Housing

1 views
Bounding box
216 × 60.4 × 136 mm
Engine
3D Printing B-rep
Parameters
14
Published
November 16, 2026

Download

Free to download and use. See the terms.

The prompt

so the mirrors stay parallel. Inside the flat front section, cut a hollow interior cavity and add two parallel perimeter grooves—each 3.2 mm wide and 4 mm deep, spaced 19 mm apart—to hold two 3 mm flat acrylic sheets, leaving a flat 19 mm inner wall between them for an LED strip. On the flat front face, add 14 evenly spaced vertical louver bars (each 4 mm wide and 5 mm thick) spanning across the opening like a sci-fi thruster grille, plus an 8 mm wide outer perimeter mounting flange. On the back side of the housing, add an extra 12 mm thick solid backing pad behind the rear mirror groove, and cut a smooth, shallow concave horizontal arc across the back mounting face so the center is recessed by 8 mm relative to the left and right ends to match a tesla model y tailgate. Finally, add a 5 mm diameter wire exit hole through the bottom center of the back wall."

Parameters

NameValueRange
Cavity/opening width200 mm50 – 400
Cavity/opening height120 mm50 – 300
Wall thickness and flange width8 mm3 – 15
Front face and louver thickness5 mm3 – 10
Number of louver bars14 mm4 – 30
Width of each louver bar4 mm2 – 10
Width of acrylic sheet grooves3.2 mm2 – 6
Depth of acrylic sheet grooves4 mm2 – 8
Flat wall between the two grooves19 mm5 – 50
Gap from front face to first groove5 mm2 – 20
Gap from second groove to back wall5 mm2 – 20
Extra backing pad thickness12 mm5 – 30
Concave recess at center of back face8 mm2 – 20
Wire exit hole diameter5 mm2 – 10

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.