Storm Peg

Step 1: Build the Main Flat BodyDrag a Box onto the workplane.Change its dimensions to roughly 25mm wide, 4mm deep, and 35mm tall to create the flat base paddle.Drag a Cylinder onto the board, rotate it 90 degrees horizontally, and crush its thickness down to 4mm to match the box.Align the cylinder with the bottom edge of the box and use the Group tool to merge them. This creates the smooth, rounded bottom handle.Step 2: Create the Three Top ProngsDrag a new Box onto the workplane for the outer prongs. Make it 4mm wide, 4mm deep, and 30mm tall.Duplicate this box, and move the second copy 21mm to the right. These form the two outer straight legs.For the center wave-shaped prong, drag a Scribble shape or combine two thin boxes slightly tilted (using the rotation tool at 5-10 degrees) to form a subtle, flexible zig-zag shape. Make it 5mm wide, 4mm deep, and 35mm tall so it stands slightly higher than the outer prongs.Move this wave prong directly into the dead center between the two outer legs.Select all three prongs and the main body, then click Align to center them horizontally, and Group them together.Step 3: Cut the Line Entry SlotsDrag a Hole Box onto the workplane. Adjust its dimensions to 2mm wide, 6mm deep, and 25mm tall.Place this hole box right in the gap between the left prong and the center wave prong. It should cut deep down into the solid body paddle.Duplicate this hole box and slide it into the gap between the right prong and the center wave prong.Select the main assembly and the two hole boxes, then click Group. This slices out the channels, creating the independent, springy plastic prongs.Step 4: Add the Ergonomic Finger GripsDrag a Cylinder Hole onto the workplane. Change its size to 16mm diameter.Turn it sideways and flatten its depth to 2mm.Push it slightly into the face of the rounded bottom handle to act as a thumb indentation.Drag a few small, thin Wedge Holes or low-profile Box Holes (0.5mm high) to create the horizontal ribbed lines across the grip zone.Highlight everything one final time and click Group.Color your finished model Blue, Green, or Orange to match the original storm pegs

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.