3D preview of Storage Container with Detached Mounting Block
Loading the interactive model…
Interactive 3D model of Storage Container with Detached Mounting Block

Brackets and mounts

Storage Container with Detached Mounting Block

7 views
Bounding box
298.5 × 250 × 75 mm
Engine
3D Printing B-rep
Parameters
12
Published
November 15, 2026

Download

Free to download and use. See the terms.

The prompt

Separate the bottom mounting block from the main open-top storage box so they are two distinct, non-overlapping solid parts lying flat side by side on the build plate (Z = 0). Keep the bottom exterior surface of the box completely flat and smooth where the mounting block was attached. Modify the inner through-channel of the detached mounting block to have an exact square inner cross-section of 37 mm x 37 mm while maintaining solid outer walls (at least 6 mm thick on all sides). Keep all other dimensions and drainage holes unchanged.

Parameters

NameValueRange
Outer length250 mm50 – 300
Outer width250 mm50 – 300
Container height75 mm20 – 200
Outer corner radius20 mm5 – 50
Wall thickness2.5 mm1 – 10
Flat base thickness3 mm1 – 10
Drainage hole diameter6 mm2 – 15
Hole center offset from outer edge30 mm10 – 80
Inner square channel size37 mm20 – 80
Minimum wall thickness6 mm6 – 20
Mounting block length200 mm30 – 300
Additional part spacing0 mm0 – 50

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.

Storage Container with Detached Mounting Block - Free CAD Model (STEP, STL) | TextoCAD