Enclosures and housings
Stepped Mechanical Pin
- Bounding box
- 9.6 × 9.6 × 57.4 mm
- Engine
- Precision B-rep
- Parameters
- 5
- Published
- October 10, 2026
Download
Free to download and use. See the terms.
The prompt
Create a single unified 3D stepped mechanical pin with a total length of 57.4mm. The base section is a solid cylinder measuring 9.6mm in diameter and 36.6mm in length. The upper section steps down sharply to a smooth cylindrical neck measuring 5.7mm in diameter and 20.8mm in length, terminating in a sharp concentric conical point at the top.
Parameters
| Name | Value | Range |
|---|---|---|
| Base Diameter | 9.6 mm | 2 – 40 |
| Base Length | 36.6 mm | 5 – 120 |
| Neck Diameter | 5.7 mm | 1 – 30 |
| Neck Section Length | 20.8 mm | 2 – 80 |
| Conical Point Height | 3 mm | 0.5 – 15 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Cylindrical Stainless Steel Basket with Folding Handles
Design a cylindrical 304 stainless steel basket with an outer diameter of 200 mm and height of 250 mm. The basket has solid side walls with no perforations. The bottom plate contai
Immersion Cooling Enclosure
Design a sealed high-pressure dielectric immersion cooling enclosure for cylindrical battery cells. Internal cavity dimensions: 540mm length, 360mm width, 160mm height with 6mm wal
Simple BWB with Propulsion Tube
Prompt: "A simple, solid Blended Wing Body (BWB) flying wing. Dimensions: wingspan 6.5 meters, center chord 1.53 meters, root thickness 35 centimeters, tapering to 15 centimeters a
Engranaje recto 50 dientes, módulo 2
Engranaje recto de 50 dientes, diámetro exterior 104 mm, diámetro de raíz 95 mm, espesor 10 mm y ángulo de presión 20°. Crear como sólido 3D con un agujero central de 8.2 mm de diá
G+1 Party Hall Structural Shell
G+1 Party Hall – AutoCAD Design Prompt Design a G+1 RCC-framed Party Hall in AutoCAD with detailed Ground Floor Plan, First Floor Plan, and all-side elevations (front, rear, left
Rope Winch Drum
Create a fully parametric CAD model of a rope winch drum for a construction hoist. Requirements: - Output format: STEP (.step or .stp) - Units: millimeters - Solid body only (no