Mechanical parts
sloped arm with pusher pin
- Bounding box
- 13.3 × 10.4 × 16.6 mm
- Engine
- 3D Printing B-rep
- Parameters
- 11
- Published
- November 20, 2026
Download
Free to download and use. See the terms.
The prompt
starting at X = 1.1 mm, with a length of 11.1 mm, width of 8.2 mm (centered on Y = 0), and height of 9.5 mm. Cut a sloped top surface on this arm so the inner edge at X = 1.1 mm has a height of 7.3 mm and the outer edge at X = 12.2 mm has a height of 9.5 mm. Add a 0.6 mm fillet to the top and vertical edges of the arm. Third, on the bottom face of the skirt (Z = -1.2 mm), extrude a cylindrical pusher pin at X = 7.2 mm, Y = 0 with a diameter of 4.2 mm and downward height of 6.0 mm.
Parameters
| Name | Value | Range |
|---|---|---|
| Arm start X | 1.1 mm | 0.5 – 10 |
| Arm length | 11.1 mm | 5 – 40 |
| Arm width | 8.2 mm | 4 – 30 |
| Arm outer edge height | 9.5 mm | 5 – 30 |
| Arm inner edge height | 7.3 mm | 3 – 30 |
| Fillet radius | 0.6 mm | 0.2 – 2 |
| Skirt bottom Z | -1.2 mm | -5 – 0 |
| Pusher pin X | 7.2 mm | 0 – 20 |
| Pusher pin Y | 0 mm | -10 – 10 |
| Pusher pin diameter | 4.2 mm | 2 – 8 |
| Pusher pin downward height | 6 mm | 2 – 15 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →SWYFT Reference-Style 3.5 inch Mold 16mm
One-piece open casting mold following the user's uploaded SWYFT wheel design brief. Outside diameter including rounded tabs: 88.9 mm. Cavity thickness: 16 mm. 12 curved spokes. Cir
Stepped Shaft with Keyway
Create a stepped cylindrical shaft in C45 steel, length 120 mm, diameter 30 mm, featuring an 8x7 mm parallel keyway slot."
Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
Two-Joint Robotic Arm with Parallel Gripper
i want a 2 joint robotic arm with parallel gripper simple design. Servo-Base: smart/serial-bus servo, true 360° positional control. Turret rides on a bearing so the servo only driv
