Sensor PCB Assembly

do the engg diagram,  Circle of 130 mm dia a square within the circle of side 75mm, both the centre of the circle and the circle and square coincde, and the square should not be in the CAD, square drawn such that the 1mm dia circle can be constructed at the corners of the square not, so the CAD should be like four 10 mm circles within the big circle of 130mm equally spaced from each other, Within that i want u to place the below things, but ensuring nothing on top of the 4 cicrles as they should be etched out a rectangle named BNO055: 25.4mm x 20.32 mm a rectangle named BME280: 15.5mm × 12 mm a rectangle name JST Connector (4 Pin GPS): 9.16 mm x 1 mm a rectangle named ESP32 S3: 27.94 mm x 57.15 mm a rectangle name JST Connector (2 Pin UART MCU-MCU): 4.58 mm x 1mm a rectangle name JST Connector (3 Pin Lid Servo): 9.16 mm x 1 mm a rectangle name JST Connector (3 Pin P2 Actuation): 9.16 mm x 1 mm a rectangle name JST Connector (3 Pin P2 Actuation): 9.16 mm x 1 mm a rectangle named BMP280: 20mm × 20 mm a rectangle named ICM-20948: 20mm × 17 mm a rectangle name JST Connector (3 Pin Lid power rail): 9.16 mm x 1 mm a rectangle name SD Card Logger: 24mm x 45mm if the components dont fit inside the given dimensions then lremme know go ahead and generate the most acccurate CAD Engg drawing

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.