Scalloped Decorative Box with Lion Emblem

Create a clean, dimensionally consistent, watertight 3D model of a decorative wooden box and export the complete assembly as an OBJ file. The object has a low, horizontally elongated rectangular footprint with an approximate 2:1 length-to-width ratio. Build the model parametrically and center it on the global origin. Maintain bilateral symmetry about the longitudinal and transverse center planes. The assembly consists of four primary elements: an upper lid, a lower base, a decorative wall enclosure, and a separate top emblem. TOP LID: Model a flat solid plate with a symmetrical scalloped perimeter. Define the plan-view outline using tangent-continuous Bézier curves or splines. The long edges alternate between shallow concave sections and broad convex lobes. The short ends contain smooth, broad outward curves. Eliminate sharp corners and discontinuous transitions. Apply consistent fillets or roundovers to all exposed perimeter edges. The lid must overhang the wall enclosure on all sides. BOTTOM BASE: Create a second solid plate below the enclosure using a matching scalloped plan-view profile. Maintain proportional overhang and apply consistent edge fillets. Align the base concentrically with the lid. SIDE ENCLOSURE: Position the wall structure inside the perimeter of the lid and base. Construct four solid vertical corner posts as the primary structural members. Add narrow vertical dividers between decorative panels. Create repeated ornamental cut-through panels along the long walls. Each panel must be generated from a symmetrical 2D sketch, mirrored about its vertical centerline, then extruded through the wall thickness using Boolean subtraction. The cutout geometry consists of pointed arches, elongated teardrop voids, curved branches, and smaller symmetrical ornamental openings. Use smooth spline geometry with tangent-continuous transitions. Maintain sufficient material bridges between all cutouts for structural integrity. Array the repeated panels at equal spacing along the length. The central wall enclosure should occupy approximately 50–60% of the total object height. The upper and lower plates create recessed shadow lines around the enclosure. TOP EMBLEM: Center a thin circular ring on the top surface. Place a separate flat, stylized lion-head silhouette inside the ring. Construct both as closed, manifold solids with clean boundaries. Use consistent wall thickness, clean Boolean operations, and appropriate edge bevels or fillets. All geometry must be manifold and watertight, with no open boundaries, intersecting faces, duplicate surfaces, or non-manifold edges. Preserve separate object groups for the lid, base, wall enclosure, and emblem. Final output: a clean, correctly scaled OBJ file containing the complete assembled 3D model.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.