Mechanical parts
Robotic Arm
- Bounding box
- 152.2 × 78 × 171.8 mm
- Engine
- 3D Printing B-rep
- Parameters
- 20
- Published
- November 21, 2026
Download
Free to download and use. See the terms.
The prompt
create a robotic arm
Parameters
| Name | Value | Range |
|---|---|---|
| Base plate diameter | 78 mm | 40 – 140 |
| Base plate thickness | 10 mm | 4 – 30 |
| Turret hub diameter | 46 mm | 20 – 90 |
| Turret hub height | 8 mm | 3 – 25 |
| Turret disc diameter | 46 mm | 20 – 90 |
| Turret disc height | 10 mm | 4 – 30 |
| Shoulder fork outer width | 26 mm | 16 – 50 |
| Shoulder fork slot width | 15.6 mm | 8 – 40 |
| Shoulder pivot height | 46 mm | 25 – 100 |
| Top of shoulder cheeks | 58 mm | 30 – 130 |
| Shoulder-to-elbow length | 70 mm | 30 – 150 |
| Upper arm angle above horizontal | 62 deg | 0 – 90 |
| Upper arm thickness | 16.6 mm | 8 – 40 |
| Elbow-to-wrist length | 55 mm | 25 – 150 |
| Forearm angle below horizontal | 25 deg | -80 – 80 |
| Forearm thickness | 9.4 mm | 6 – 30 |
| Jaw length | 26 mm | 10 – 60 |
| Jaw opening | 10 mm | 4 – 40 |
| Jaw thickness | 5 mm | 2 – 12 |
| Jaw width | 18 mm | 8 – 40 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →SWYFT Reference-Style 3.5 inch Mold 16mm
One-piece open casting mold following the user's uploaded SWYFT wheel design brief. Outside diameter including rounded tabs: 88.9 mm. Cavity thickness: 16 mm. 12 curved spokes. Cir
Stepped Shaft with Keyway
Create a stepped cylindrical shaft in C45 steel, length 120 mm, diameter 30 mm, featuring an 8x7 mm parallel keyway slot."
Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
Two-Joint Robotic Arm with Parallel Gripper
i want a 2 joint robotic arm with parallel gripper simple design. Servo-Base: smart/serial-bus servo, true 360° positional control. Turret rides on a bearing so the servo only driv
