3D preview of Rectangular Electronics Enclosure with Standoffs and Mounting Tabs
Loading the interactive model…
Interactive 3D model of Rectangular Electronics Enclosure with Standoffs and Mounting Tabs

Brackets and mounts

Rectangular Electronics Enclosure with Standoffs and Mounting Tabs

1 views
Bounding box
110.0 × 100.0 × 30.0 mm
Engine
Precision B-rep
Parameters
19
Published
November 20, 2026

Download

Free to download and use. See the terms.

The prompt

"Create a rectangular electronics enclosure box measuring 100 mm length, 70 mm width, and 30 mm height, with 2.5 mm wall thickness and 4 mm rounded outer vertical corners. Inside the bottom floor, add four cylindrical PCB mounting standoffs of 6 mm outer diameter, 3 mm inner hole diameter, and 5 mm height, positioned 10 mm inward from each corner. On the front 70 mm wall, cut a rectangular USB power slot measuring 10 mm wide by 4 mm high centered 8 mm from the bottom. On the right 100 mm wall, cut two circular holes of 6 mm diameter spaced 20 mm apart for moisture sensor probe leads. On the left and right outer walls, add two flat mounting tabs 15 mm wide and 3 mm thick with 4 mm screw holes."

Parameters

NameValueRange
Length (front-to-back)100 mm40 – 200
Width (left-to-right)70 mm30 – 150
Height30 mm15 – 100
Wall Thickness2.5 mm1 – 8
Outer Vertical Corner Radius4 mm0 – 10
Standoff Outer Diameter6 mm3 – 15
Standoff Inner Hole Diameter3 mm1 – 5
Standoff Height5 mm2 – 20
Standoff Inset From Inner Corner10 mm2 – 30
USB Slot Width10 mm4 – 40
USB Slot Height4 mm2 – 12
USB Slot Center From Bottom8 mm2 – 25
Sensor Probe Hole Diameter6 mm2 – 20
Sensor Probe Hole Spacing20 mm5 – 80
Sensor Probe Hole Height15 mm2 – 25
Mounting Tab Width15 mm8 – 40
Mounting Tab Thickness3 mm1 – 8
Mounting Tab Protrusion20 mm5 – 40
Mounting Tab Screw Hole Diameter4 mm2 – 10

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.