Micro RC Airplane Frame

Create a lightweight 3D-printable indoor micro RC airplane frame. The fuselage is a hollow rectangular boom 200 mm long, 3 mm wide, and 3 mm tall, with an open U-shaped electronics tray at the front nose measuring 45 mm long, 14 mm wide, and 8 mm deep with 1 mm walls. Mounted on top of the fuselage, 50 mm back from the front nose, is a main wing with a 260 mm total wingspan, 80 mm chord width, and 0.6 mm thickness, angled upward from the center at a 10-degree dihedral V-angle. On the front leading edge of the wing, spaced 35 mm left and right of the center fuselage, attach two hollow cylindrical motor pods measuring 16 mm long with an 8.5 mm outer diameter and a 7.1 mm inner through-hole for 7 mm coreless motors. At the rear end of the fuselage boom, attach a flat horizontal tail stabilizer 90 mm wide, 35 mm long, and 0.4 mm thick, and a vertical tail fin 45 mm tall, 35 mm long, and 0.6 mm thick.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.