Raptor Console Insert V6 - Brass Socket Final Prototype

1 views

Bounding box: 214 × 38 × 43.0 mm
Engine: 3D Printing B-rep
Parameters: 17
Published: November 13, 2026

Download

Free to download and use. See the terms.

The prompt

One-piece PLA-printable console T insert; 214x38x12 deck, 31mm tapered stem with 1mm allowance for tape over existing rubber mat, three inline 7.5mm x 5.5mm heat-set pockets with 6.6mm through-clearance for 1/4-20 hardware. Poles are NOT included.

Parameters

Name	Value	Range
Deck length	214 mm	211 – 220
Deck width	38 mm	35 – 43
Deck thickness	12 mm	10 – 15
Stem top length	209.5 mm	207 – 211
Stem top width	15.5 mm	14.5 – 16.2
Stem bottom length	190 mm	185 – 198
Stem bottom width	13 mm	12 – 14
Stem depth, leave 1 mm for tape on mat	31 mm	28 – 33
Left/front end inset	19.5 mm	15 – 22
Right/rear end inset	0 mm	0 – 4
Stem rounded plan corners	4 mm	3 – 5
Deck corner radius	2 mm	1 – 3
Top outer edge round	2 mm	1 – 3
Inline center spacing	65 mm	60 – 70
Pilot socket for 8mm OD brass insert	7.5 mm	7.2 – 7.8
Brass insert socket depth	5.5 mm	5 – 6.5
Male screw clearance below insert	6.6 mm	6.4 – 6.9

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.

More models

Browse the full gallery →

600.0 × 400.0 × 450.0 mmPrecision

Table

Make a table of height 45 cm

STEPSTLGLB5 PARAMS

700.6 × 2000.6 × 2000.0 mmPrecision

Haul‑off Reel

Make this haul off reel, the dimensions of it should be a 2 meter diameter circle shaper with 0.7 meter width, i have attached a picture of what it looks like

STEPSTLGLB6 PARAMS

664.7 × 664.7 × 1380.1 mmPrecision

旋转式卷烟陈列架

物件名称：旋转式卷烟陈列架（带语音播报）整体形态：一个圆柱形、可360度旋转的立式展示架。整体高度为1380mm，直径为600mm。底部配有4个带刹车的万向轮，方便移动和固定。结构分层（从下往上）：底座（0-200mm高度）：底部为圆柱形底座，高200mm。外层采用网格状设计（类似金属网孔或菱形网格）。底座内部中空，用于内置音箱设备。

STEPSTLGLB24 PARAMS