QM-CV-05-BT Vertical Treat Clicker (V1)

***PART 1 Let me know when ready for PART 2 of spec*** # QM-CV-05-BT — revised V1 design baseline Status: concept requirements updated following the latest user clarifications; no CAD geometry or functional validation yet. Sources: `v3_treat_clicker_spec.md`, `clicker_review_updates.md` and subsequent user clarifications. Later decisions supersede earlier source requirements where they conflict. Other SKUs are out of scope. ## Accepted changes | Item | Revised requirement | |---|---| | SKU | QM-CV-05-BT only: vertical cylindrical, half-cup target, black textured chassis | | Main envelope | Diameter 62 mm × height 132 mm. The user has approved prioritizing approximately half-cup usable capacity over the former 104 mm height. Rear mount projection is additional unless later specified otherwise. | | Capacity | Nominal usable fill target 118.3 cm³ (0.5 US cup). At the retained Ø62 × 132 mm envelope, the Ø53 mm conservative-bore layout estimates 118.6 cm³ at Z = 120.5 mm after a 10 cm³ intrusion allowance, plus 16.5 cm³ headspace. An unlined Ø57 mm bore would yield a different volume and fill line. Neither estimate is a measured CAD volume. Do not apply a second packing-factor deduction to bulk measuring-cup capacity. | | Bottom trigger | Entire circular bottom plate is the trigger, replacing the 42 × 20 mm inset bar. Flat and flush at rest; nominal 10 mm upward stroke and 4 mm forward jackpot travel. No hanging loops or trays. | | Hopper / food path | The removable cartridge/core and its retention, release and drive-disengagement features are completely out of scope. Use a fixed hopper and funnel within the chassis; food-contact construction, rotor service access and cleaning method remain to be designed. |

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.