Brackets and mounts
Partitioned Electronics Box
- Bounding box
- 76 × 119 × 54 mm
- Engine
- 3D Printing B-rep
- Parameters
- 12
- Published
- November 11, 2026
Download
Free to download and use. See the terms.
The prompt
Create a 3D printable electronics box. Internal length is 72mm, total internal width is 115mm, internal height is 50mm. Wall thickness is 2mm. Add a permanent vertical internal partition wall that divides the box into two sections: the left section (for battery holder) must have an internal width of 58mm, and the right section (for UPS circuit) must have an internal width of 55mm. On the outer wall of the right section, add two square holes for cable routing, each sized 12x8mm. Also, generate a matching simple flat top lid for this box.
Parameters
| Name | Value | Range |
|---|---|---|
| Internal length X | 72 mm | 20 – 200 |
| Internal width Y | 115 mm | 20 – 300 |
| Internal height Z | 50 mm | 10 – 150 |
| Wall thickness | 2 mm | 1.2 – 6 |
| Floor thickness | 2 mm | 1.2 – 6 |
| Left (battery) compartment width | 58 mm | 10 – 210 |
| Partition thickness | 2 mm | 1.2 – 6 |
| Hole width along X | 12 mm | 4 – 30 |
| Hole height along Z | 8 mm | 3 – 20 |
| Hole centre height above base | 30 mm | 6 – 44 |
| Centre-to-centre spacing along X | 40 mm | 0 – 70 |
| Lid plate thickness | 2 mm | 1.2 – 8 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
SG90 2-DOF Robotic Arm Assembly
"Design a compact, 3D-printable 2-DOF robotic arm specifically for a mobile library robot. The arm should consist of a rotating base joint, a lower link, an upper link, and a simpl