Open-Top Enclosure Box

Create a hollow rectangular box with an open top. The outer dimensions are 95 mm wide, 75 mm deep, and 125 mm high. The wall thickness is 2 mm. On the front face, subtract a rectangular cutout 35 mm wide and 28 mm high, centered horizontally, and positioned 75 mm from the bottom base. Subtract four 3.2 mm circular holes around this cutout in a rectangle 53 mm wide and 30 mm high. Below the rectangular cutout on the front face, add a hollow cylinder pointing outward. It has an outer diameter of 22 mm, an inner diameter of 16.5 mm, and a length of 10 mm. On the back face, subtract a 9.5 mm wide by 4.5 mm high rectangular cutout flush with the bottom floor. On the upper half of the back face, add an internal circular ring protruding 5 mm inward, with an inner diameter of 51 mm and an outer diameter of 55 mm. Inside this ring, subtract a grid of 3 mm holes through the back wall. On the inside bottom floor, add two rectangular ridges running horizontally. Each ridge is 10 mm high, 2 mm thick, and 65 mm long, centered horizontally. Position the first ridge 15 mm from the back wall and the second ridge 39 mm from the back wall. On the inside of the left side panel, add four cylindrical standoffs extending 10 mm inward. Each standoff is 6 mm in diameter with a 2.5 mm central pilot hole. Arrange them in a 21 mm by 46 mm rectangle. In the four top inside corners of the box, add four vertical cylindrical pillars extending downward by 15 mm. Each pillar has a 6 mm outer diameter and a 2.5 mm vertical pilot hole.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.