Makita 18V LXT Battery Wall Mount

Product Spec Sheet: Makita 18V LXT Vertical Drop-In Battery Wall Mount (Single Bay)Core Function & Target AudienceProduct Concept: A rugged, standalone single-bay wall mount for Makita 18V LXT batteries featuring a top-drop vertical insertion slot and a locking retention lip.Target Audience: Woodworkers, contractors, and DIYers looking to clean up workbench clutter and organize battery storage on van walls, workshop French cleats, or timber studs.Exact Dimensions & TolerancesMakita 18V LXT Battery Envelope: $113\text{ mm (L)} \times 75\text{ mm (W)} \times 62\text{ mm (H)}$ (standard physical profile for variants like the BL1850B 5.0Ah). Two-Stage Slot Profile:Upper Guide / Slide Rails: Designed to interface with the top rail tracks (~$40\text{ mm}$ spread with a $+0.6\text{ mm}$ CAD clearance for a smooth, rattle-free vertical drop).Lower Housing Clearance: Widened body cavity ($\ge 76\text{ mm}$ width clearance) to let the full $75\text{ mm}$ wide battery housing and locking latch slide straight down without interference.Mounting Backplate: $55\text{ mm} \times 95\text{ mm}$ footprint with two countersunk screw holes sized for standard #8 or M4 wood screws.Wall Thickness: $4\text{ mm}$ solid perimeters throughout the structural load paths.Printability Notes (Bambu A1 Optimized)Material: PETG recommended for impact resistance and slight flex; high-toughness PLA is a solid alternative.Orientation: Print flat on its rear mounting plate face against the build plate so layer lines run parallel to the insertion axis, maximizing strength.Supports: Zero supports required if designed with self-supporting 45-degree chamfers on the internal overhangs.Settings: 4 wall loops/perimeters, 25% Gyroid or Grid infill.Ready-to-Use CAD PromptDesign a 3D-printable single-bay wall mount for Makita 18V LXT batteries, referencing the full 113mm x 75mm x 62mm battery envelope. The battery must drop straight down from above into a vertical slot. The internal geometry must feature a two-stage profile: upper guide rails matching the ~40mm track interface with 0.6mm total clearance for a smooth glide, and a lower housing clearance of at least 76mm width to accommodate the main 75mm wide battery body and locking latch. Dimensions: base mounting plate 55mm wide by 95mm high with two countersunk screw holes for M4/No.8 screws. Designed to print flat on its rear mounting face with a solid 4mm wall thickness, 4 perimeters, and zero supports.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.