Brackets and mounts
Infinity Mirror Tailgate Housing
- Bounding box
- 196 × 42.4 × 126 mm
- Engine
- 3D Printing B-rep
- Parameters
- 14
- Published
- November 16, 2026
Download
Free to download and use. See the terms.
The prompt
so the mirrors stay parallel. Inside the flat front section, cut a hollow interior cavity and add two parallel perimeter grooves—each 3.2 mm wide and 4 mm deep, spaced 19 mm apart—to hold two 3 mm flat acrylic sheets, leaving a flat 19 mm inner wall between them for an LED strip. On the flat front face, add 14 evenly spaced vertical louver bars (each 4 mm wide and 5 mm thick) spanning across the opening like a sci-fi thruster grille, plus an 8 mm wide outer perimeter mounting flange. On the back side of the housing, add an extra 12 mm thick solid backing pad behind the rear mirror groove, and cut a smooth, shallow concave horizontal arc across the back mounting face so the center is recessed by 8 mm relative to the left and right ends to match a tesla model y tailgate. Finally, add a 5 mm diameter wire exit hole through the bottom center of the back wall."
Parameters
| Name | Value | Range |
|---|---|---|
| Overall width | 180 mm | 60 – 400 |
| Overall height | 110 mm | 40 – 300 |
| Perimeter wall thickness | 7 mm | 5 – 15 |
| Groove width | 3.2 mm | 3 – 6 |
| Groove depth | 4 mm | 2 – 8 |
| LED wall between the two grooves | 19 mm | 5 – 80 |
| Mounting flange width | 8 mm | 3 – 25 |
| Mounting flange thickness | 5 mm | 2 – 15 |
| Number of louver bars | 14 mm | 3 – 40 |
| Louver bar width | 4 mm | 1 – 12 |
| Louver bar thickness | 5 mm | 2 – 12 |
| Solid backing pad thickness | 12 mm | 3 – 30 |
| Concave arc centre recess | 8 mm | 0.5 – 25 |
| Wire exit hole diameter | 5 mm | 2 – 12 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
JZX100 Gas Cap Holder
can you make a gas cap holder for a jzx100 chaser. i want you to refer to the image and make a cad very close to the picture
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
