Hillside Pump House Shed

Lonie pump house Existing is rectangle box style With lattice and tarp over it. Building new taller pump house With lattice walls Plywood roof , tar paper & Composition shingle roofing charcol grey color. Roof slopes to back Roof hangs over 6” typical all sides. This is built into a hill side Thats why back is so short. W = 9’6” Depth 5’ Fromt Height 6’ 2 Front doors 6’tall 4’ wide ea Double Doors meet in middle and bottom open from center Right door notched on bottom So it will fully open over a step that in the way Side panel access door 2’w x 3’ tall Side height 5’ tall in front back on hillside is 3’ 6”high Back height 3’ 6”tall Pipes come in at bottom lower left corner in back want the shed to be 6’ in front 2 gate doors full height & open from center of double doors. It will have a Solid roof on top with gray composit shingles. The roof slopes down to back so its cant be seen from front view. There are double doors that open from center no post in center, needs a wide clear opening The right door has cut out on bottom so door can open over a step. The next door is same height but stops before shed steps up onto retaining wall as shown in image. The last skinny section is shown shorter because its bottom is up on ledge Show me a couple diferent styles 1 all new lattice 1 fencing on bottom 2/3 & top 1/3 lattice 1 horizontal fence planks with small gaps for air between boards The right side of the rectangle room Viewed from exterior has an small access door to get to circut breaker panel inside the enclosure

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.