Hazelnut Drying Tray

Create ONE modular steel tray for a hazelnut drying machine. Use millimeters only. IMPORTANT: Create only the tray described below. Do not add wheels, rails, legs, handles, motors, fans, ducts or any other components. Do not invent or modify dimensions. MAIN FRAME Overall external frame dimensions: Length = 2000 mm Width = 1500 mm Use square hollow steel tube: 40 mm x 40 mm Wall thickness = 2 mm The tubes must be hollow, not solid. Create: 2 longitudinal tubes: 2000 mm long 40 x 40 x 2 mm square hollow section 2 transverse end tubes: 1420 mm long 40 x 40 x 2 mm square hollow section Place the 1420 mm end tubes BETWEEN the two 2000 mm longitudinal tubes. The finished external frame size must be exactly: 2000 mm x 1500 mm. INTERNAL SUPPORTS Add exactly 5 transverse internal support tubes. Each support: Length = 1420 mm Section = 40 x 40 x 2 mm square hollow tube All 5 supports must run parallel to the 1420 mm end tubes. Distribute them uniformly along the 2000 mm direction. Clear gap between adjacent transverse tubes: 286.667 mm Center-to-center spacing: 326.667 mm The arrangement must be symmetric. FLOOR PLATE Add one flat steel floor plate on top of the frame. Dimensions: 1920 mm x 1420 mm Thickness = 2 mm Center the plate inside the outer frame. The plate must rest on the frame and the five internal supports. IMPORTANT: Do NOT create perforation holes. Keep the floor plate completely solid and flat. Perforations will be designed later. SIDE WALLS Create four vertical steel side walls. Wall thickness: 2 mm Wall height: 200 mm Create: 2 longitudinal walls: 2000 mm x 200 mm x 2 mm 2 transverse walls: 1496 mm x 200 mm x 2 mm The two 1496 mm transverse walls must fit between the two 2 mm thick longitudinal walls. The four walls must form an open-top rectangular tray. The tray is intended to contain a maximum hazelnut bed depth of 150 mm, leaving approximately 50 mm freeboard. FINAL CHECK Verify before completing: Overall external tray length = 2000 mm Overall external tray width = 1500 mm Structural tube = 40 x 40 x 2 mm hollow square tube Number of internal supports = exactly 5 Internal support length = 1420 mm Floor plate = 1920 x 1420 x 2 mm Side wall height = 200 mm Keep individual structural members and plates as separate bodies/components if supported by the CAD system. Do not create anything other than this tray.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.