Handheld Scanner Base Housing

Modify only the orientation and location of the battery tunnel opening. The current battery opening is incorrectly located on the 284 mm-wide front face. Close that entire long front face with a continuous 4 mm wall. Use this coordinate definition: - X axis: 284 mm left-to-right width - Y axis: 95 mm front-to-back depth - Z axis: 128 mm vertical height Place the battery insertion opening only on the left end face at minimum X. This is the short 95 mm × 128 mm face. Left-side opening: - 70 mm wide in the Y direction - 120 mm high in the Z direction - Centered front-to-back within the 95 mm depth - Bottom edge positioned 4 mm above the exterior bottom - 3 mm opening corner radius Create a continuous straight tunnel from the left end face in the positive X direction for 220 mm. The battery must slide left-to-right along the 284 mm width axis. Add a solid internal stop wall perpendicular to the X axis at 220 mm from the left exterior face. Requirements: - No opening on the front long face - No opening on the rear long face - No opening on the right end face - Battery enters and exits exclusively through the short left end - Preserve the hollow right-side electronics compartment - Preserve all existing parameters and exterior dimensions - Preserve 4 mm walls and the flat top and bottom - Do not add any other features

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.