Brackets and mounts
H-Shaped Mounting Bracket with Angled Arm
- Bounding box
- 64 × 217.1 × 139.9 mm
- Engine
- 3D Printing B-rep
- Parameters
- 15
- Published
- November 16, 2026
Download
Free to download and use. See the terms.
The prompt
Create a lightweight H-shaped mounting bracket with a 20-degree upward-angled carrier arm. The backplate is 64 mm wide, 130 mm tall, and 8 mm thick, with large rectangular cutouts on the left and right sides leaving a 24 mm wide center vertical spine and 25 mm tall top and bottom bars. Drill four 6.5 mm diameter M6 bolt holes spaced 38 mm apart horizontally and 105 mm apart vertically. From the center of the backplate, extend a 50 mm wide, 220 mm long, 8 mm thick flat support arm forward, angled 20 degrees upward from perpendicular, supported underneath by a triangular gusset rib connecting to the lower center spine.
Parameters
| Name | Value | Range |
|---|---|---|
| Backplate width | 64 mm | 40 – 120 |
| Backplate height | 130 mm | 80 – 200 |
| Backplate thickness | 8 mm | 4 – 16 |
| Center vertical spine width | 24 mm | 15 – 50 |
| Top and bottom bar height | 25 mm | 15 – 50 |
| Horizontal hole spacing | 38 mm | 20 – 100 |
| Vertical hole spacing | 105 mm | 40 – 180 |
| M6 clearance hole diameter | 6.5 mm | 3 – 12 |
| Arm width | 50 mm | 30 – 100 |
| Arm length | 220 mm | 100 – 300 |
| Arm thickness | 8 mm | 4 – 16 |
| Upward tilt angle | 20 deg | 0 – 45 |
| Gusset rib thickness | 8 mm | 4 – 16 |
| Gusset reach along arm | 140 mm | 50 – 200 |
| Gusset drop along spine | 55 mm | 20 – 100 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
JZX100 Gas Cap Holder
can you make a gas cap holder for a jzx100 chaser. i want you to refer to the image and make a cad very close to the picture
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
