Mechanical parts
Full donut door handle
- Bounding box
- 70 × 70 × 32 mm
- Engine
- 3D Printing B-rep
- Parameters
- 6
- Published
- November 17, 2026
Download
Free to download and use. See the terms.
The prompt
one full-donut door handle (circular cross-section) so there is something to pull on, single attachment point, center hole basically a dot, dark green
Parameters
| Name | Value | Range |
|---|---|---|
| Outer diameter of the donut | 70 mm | 40 – 120 |
| Center dot diameter | 2 mm | 1 – 5 |
| Center dot depth | 1.5 mm | 0.6 – 4 |
| Flat cut off the back for door contact - smaller = more undercut | 2 mm | 0.5 – 8 |
| Center blind hole: 5.6 = M4 heat-set insert, 3.4 = M4 self-tapping | 5.6 mm | 3 – 8 |
| Center blind hole depth | 8 mm | 4 – 15 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Stepped Shaft with Keyway
Create a stepped cylindrical shaft in C45 steel, length 120 mm, diameter 30 mm, featuring an 8x7 mm parallel keyway slot."
Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
M6 Thumb Screw
Create ONLY a mechanical thumb screw. This is NOT a knob. Create a real M6 thumb screw used in industrial machinery. Features: • Circular head 22 mm diameter • Head height 12 m
Engine Piston
make me a cylinder/piston for an engine. The bottom hole to connect to the cranckshaft needs to be 24 mm in diameter
