Flipper-Gehäuse V2 – Base + Lid

TextoCAD Prompt V2 — Flipper-Gehäuse (komplett, korrigiert) ÄNDERUNGEN GEGENÜBER V1 Displayfenster: 40x40 -> 26x26 mm, verschoben (nicht zentriert) Standoffs: jetzt als echte erhabene Säulen mit Bohrung explizit NEU: Ladeport-Ausschnitt in Seitenwand (USB-C laden ohne Deckel öffnen) Deckel + Unterteil in EINEM Prompt (eine Datei) PROMPT (alles auf einmal — kopieren) Design a two-part 3D-printable enclosure, output both parts in one model placed side by side. PART 1 - BASE: A rectangular box, outer dimensions 83 mm long x 63 mm wide x 30 mm tall, wall thickness 2.5 mm, floor thickness 2 mm, open at the top. Round the four vertical outer edges with 3 mm radius. Inside on the floor, add four raised cylindrical standoffs, each 6 mm diameter and 4 mm tall, with a 2.3 mm diameter hole down the center of each, arranged as a rectangle with 58 mm spacing along the length and 23 mm spacing along the width, centered in the box floor. On one short end wall cut a rectangular opening 18 mm wide x 8 mm tall for a USB connector, 3 mm above the floor. On one long side wall cut a second rectangular opening 12 mm wide x 6 mm tall for a USB-C charging port, 3 mm above the floor. On the opposite long side wall cut a 4 mm diameter round hole for an antenna, near the top. PART 2 - LID: A rectangular lid 83 mm long x 63 mm wide x 2.5 mm thick, four outer edges rounded 3 mm radius. Cut a square display window 26 mm x 26 mm, positioned so its center is 27 mm from the left short edge and 13 mm from one long edge (not centered). On the underside add a rectangular snap-fit lip, outer size 77.5 mm x 57.5 mm, 3 mm tall, wall thickness 2.5 mm, to click into the base. MASSE-ÜBERSICHT Feature Wert Status Gehäuse aussen 83 x 63 x 30 mm abgeleitet Wand / Boden 2.5 / 2 mm Standard Pi-Standoffs Raster 58 x 23 mm FIX (Pi Zero) Standoff Ø6, 4mm hoch, Bohrung Ø2.3 Standard M2.5 USB-Ausschnitt 18 x 8 mm PRÜFEN USB-C Ladeport 12 x 6 mm PRÜFEN (Shield-Position) Antennenloch Ø4 mm Standard Displayfenster 26 x 26 mm aus Foto gemessen (±2mm) Display Mitte 27mm v. links / 13mm v. oben aus Foto gemessen (±2mm) Snap-Lippe 77.5 x 57.5, 3mm Standard NACH DEM GENERIEREN Slider nutzen (gratis) statt neue Generierung für Feinkorrektur Displayfenster-Position am realen Board gegenchecken vor Druck Ladeport-Position: prüfen wo USB-C am Purecrea-Shield rauskommt Export STL -> OrcaSlicer -> PETG (Snap-Fit) -> Ender 3 V3 KE Vor dem Slicen: Mesh-Repair (offene Kanten aus V1 vermeiden)

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.