3D preview of Flange Tapered Body with Ball End
Loading the interactive model…
Interactive 3D model of Flange Tapered Body with Ball End

Brackets and mounts

Flange Tapered Body with Ball End

1 views
Bounding box
110 × 40.0 × 140.0 mm
Engine
3D Printing B-rep
Parameters
12
Published
November 18, 2026

Download

Free to download and use. See the terms.

The prompt

Create a precise, fully editable 3D mechanical CAD model based on the attached technical drawing. IMPORTANT: Reproduce the geometry shown in the reference image. Do not redesign the object or simplify its characteristic shape. **UNITS AND DIMENSIONS** - Use millimeters (mm) for all measurements. - Overall height: 140 mm. - Mounting hole diameter: Ø15 mm. - Distance between the two mounting hole centers: 80 mm. - Mounting flange thickness: 12 mm. - Tapered body length: 50 mm. - Reproduce all other dimensions according to the proportions and dimension markings in the reference drawing. **1. MOUNTING FLANGE** Create a flat, elongated oval-shaped mounting flange with two rounded ends. - The flange must have two circular through-holes, one at each end. - Both holes must have a diameter of 15 mm. - The distance between their centers must be exactly 80 mm. - The external contour must have smooth rounded transitions, following the technical drawing. - Add the central circular raised boss visible in the top view. **2. CENTRAL TAPERED BODY** From the center of the underside of the mounting flange, create a downward-projecting tapered body. - The body must be aligned with the central axis of the flange. - It must have a wide section close to the flange. - Gradually reduce its diameter toward the lower end. - The tapered section must be approximately 50 mm long. - Maintain the angular and proportional appearance

Parameters

NameValueRange
Overall height140 mm100 – 200
Flange width30 mm20 – 80
Flange thickness12 mm6 – 20
Mounting hole diameter15 mm6 – 30
Hole centre distance80 mm60 – 120
Central boss diameter24 mm10 – 40
Central boss height6 mm2 – 12
Tapered body length50 mm30 – 80
Taper top diameter24 mm10 – 40
Taper bottom diameter12 mm6 – 30
Lower shaft diameter12 mm6 – 30
Bulb end diameter40 mm20 – 80

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.