Five-Cavity Candle Mold with Embossed Side Lettering

Modify the existing 3D CAD model of my five-cavity candle mold. Preserve the current tray, dimensions, and cavity arrangement. CRITICAL: CORRECT LETTER PLACEMENT Each candle is an elongated rectangular prism with four long side faces and two short end faces: a bottom end face and a top end face. The word must be embossed on ONE OF THE FOUR LONG SIDE FACES of each finished candle, NOT on the bottom end face and NOT on the top end face. Imagine the candle standing vertically on its flat bottom end face. The word must start near the bottom of the candle, where the candle stands on a surface. The word must extend vertically upward from the bottom toward the middle or beyond the middle of the candle. The word should occupy approximately 50–70% of the candle's total length, depending on the number of letters. The letters must be oriented vertically along the candle's length, with the first letter closest to the bottom and the last letter farther up. Use one broad rectangular side face, not a narrow side face. Keep the opposite three long side faces smooth and free of text. Do not place any letters on either short end face. CANDLE DIMENSIONS Length/height when standing: 140 mm. Width: 26 mm. Thickness: 23 mm. WORDS GRATITUD SALUD AMOR FE EXITO Each of the five cavities must have one different word. LETTERING GEOMETRY The letters must be real 3D geometry integrated into the mold cavity, not labels or annotations. Recess the letters 3 mm into the mold cavity so they produce raised lettering on the finished wax candle. Use bold, uppercase, easy-to-read sans-serif lettering. Center the word across the width of the broad side face. Ensure the word fits within the available length and remains legible. Correctly orient the mold lettering so the finished candle displays each word normally. MOLD REQUIREMENTS Preserve the five existing candle cavities and wick channels. Make the letters part of the actual cavity surface. Ensure the mold can release the finished candle without damaging the raised letters. If necessary, design the model as a master pattern for creating a flexible silicone mold. First show a 3D preview of one finished candle standing on its bottom end face, with the word visibly embossed on its long side from the bottom upward. Also show the complete five-cavity mold. Do not finalize the model until the letter placement matches these instructions.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.