Brackets and mounts
EV Battery Enclosure with Mounting Rails
- Bounding box
- 1600 × 1160 × 150 mm
- Engine
- 3D Printing B-rep
- Parameters
- 14
- Published
- November 15, 2026
Download
Free to download and use. See the terms.
The prompt
A single-piece rectangular EV battery enclosure measuring 1200 mm long, 1000 mm wide, and 150 mm tall with 20 mm filleted vertical corners. Along the bottom outer edges, two parallel longitudinal rectangular mounting rails run 1600 mm long with a 60 mm by 40 mm cross-section. Four flat horizontal mounting tabs extend outward from the sides of the enclosure to connect to the rails—two located 550 mm forward of the center and two located 500 mm rearward of the center—each featuring a 12 mm vertical through-hole for a mounting bolt.
Parameters
| Name | Value | Range |
|---|---|---|
| Enclosure length X | 1200 mm | 200 – 2400 |
| Enclosure width Y | 1000 mm | 200 – 2000 |
| Enclosure height Z | 150 mm | 40 – 400 |
| Vertical corner fillet | 20 mm | 0 – 60 |
| Rail length X | 1600 mm | 200 – 2600 |
| Rail cross-section width | 60 mm | 20 – 120 |
| Rail cross-section height | 40 mm | 10 – 120 |
| Clearance between body wall and rail | 20 mm | 2 – 200 |
| Tab plate thickness | 12 mm | 4 – 40 |
| Tab width along X | 80 mm | 20 – 200 |
| Front tab offset from centre | 550 mm | 0 – 1000 |
| Rear tab offset from centre | 500 mm | 0 – 1000 |
| Tab overlap into enclosure wall | 5 mm | 1 – 30 |
| Vertical bolt through-hole | 12 mm | 3 – 30 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
JZX100 Gas Cap Holder
can you make a gas cap holder for a jzx100 chaser. i want you to refer to the image and make a cad very close to the picture
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
