AAC Picture Token Body

Create one watertight 3D printable mechanical part: an AAC picture token body. Make the part as one solid body. Coordinate orientation: - The front face is the top surface. - The back face is the bottom surface. - The pull tab is on the top edge of the square. Main body: - Rounded square body - Width: 66 mm - Height: 66 mm - Thickness: 11 mm - Corner radius: 7 mm - Add a centered pull tab on the top edge - Pull tab size: 24 mm wide, 10 mm tall, 11 mm thick - Pull tab corners should be rounded - Body and tab should be joined into one solid part Front face feature: - Cut one square recessed pocket into the front/top face - Pocket size: 54 mm x 54 mm - Pocket depth: 2 mm - Pocket centered on the 66 mm square body - Leave a raised border around the pocket - The pocket must be a real recessed tray, not just an engraved line Back face features: - Cut two circular blind holes into the back/bottom face - Each hole diameter: 10.4 mm - Each hole depth: 3.2 mm - Holes are centered left-to-right - Upper magnet hole center is 16 mm above the body center - Lower magnet hole center is 16 mm below the body center - Holes must be open from the back/bottom face Finish: - Slightly fillet or round external edges - Avoid thin fragile features - Make the model one valid watertight solid - No supports required - Export as STL

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.