Mechanical parts
5 Axis Robotic Arm
- Bounding box
- 179.1 × 80 × 140.8 mm
- Engine
- 3D Printing B-rep
- Parameters
- 16
- Published
- November 21, 2026
Download
Free to download and use. See the terms.
The prompt
5 axis robotic arm
Parameters
| Name | Value | Range |
|---|---|---|
| Base diameter | 80 mm | 40 – 160 |
| Base height | 8 mm | 4 – 20 |
| Mounting hole diameter | 4.5 mm | 2 – 8 |
| Turret diameter | 46 mm | 25 – 80 |
| Turret height | 12 mm | 6 – 30 |
| Shoulder column height | 42 mm | 20 – 100 |
| Joint width | 18 mm | 12 – 30 |
| Joint hub diameter | 16 mm | 10 – 30 |
| Arm thickness | 10 mm | 6 – 20 |
| Upper arm length | 75 mm | 40 – 150 |
| Forearm length | 60 mm | 30 – 120 |
| Wrist length | 26 mm | 12 – 60 |
| Gripper finger length | 24 mm | 10 – 50 |
| Gripper opening | 14 mm | 6 – 40 |
| Shoulder lean angle | 18 deg | 0 – 45 |
| Forearm droop angle | 12 deg | 0 – 45 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →SWYFT Reference-Style 3.5 inch Mold 16mm
One-piece open casting mold following the user's uploaded SWYFT wheel design brief. Outside diameter including rounded tabs: 88.9 mm. Cavity thickness: 16 mm. 12 curved spokes. Cir
Stepped Shaft with Keyway
Create a stepped cylindrical shaft in C45 steel, length 120 mm, diameter 30 mm, featuring an 8x7 mm parallel keyway slot."
Plastic Bottle with Screw Cap
A plastic bottle with a twist-on screw cap. Adjustable bottle diameter, height, and cap height.
Copper Cold-Plate Base with Fin Channels and Face-Seal Groove
1. Copper Base Create a rectangular copper base 84 × 84 mm. Use C110 ETP copper. Finished overall base thickness is 5.70 mm. The bottom floor thickness below the channels is 2.50 m
Spring Cup
"Create a cylindrical spring cup. The main body has an outer diameter of 14 mm and a total height of 5 mm. Cut a centered recessed pocket into the top face that is 8.5 mm in diamet
Two-Joint Robotic Arm with Parallel Gripper
i want a 2 joint robotic arm with parallel gripper simple design. Servo-Base: smart/serial-bus servo, true 360° positional control. Turret rides on a bearing so the servo only driv
