Brackets and mounts
165.1 mm 6.5-inch Speaker Grille
- Bounding box
- 165.1 × 165.1 × 5.2 mm
- Engine
- 3D Printing B-rep
- Parameters
- 14
- Published
- November 15, 2026
Download
Free to download and use. See the terms.
The prompt
Create a 165.1 mm diameter speaker grille for a 6.5-inch car audio speaker. Design an aggressive automotive style with a central geometric pattern, six mounting holes, reinforced outer ring and rounded edges. Use precise millimeter dimensions. Make the model fully editable and exportable as STL.
Parameters
| Name | Value | Range |
|---|---|---|
| Outer diameter | 165.1 mm | 140 – 200 |
| Main thickness | 4 mm | 2 – 10 |
| Edge round-over radius | 1 mm | 0.3 – 3 |
| Reinforced outer ring width | 10 mm | 4 – 20 |
| Mounting hole bolt circle | 157 mm | 120 – 175 |
| Mounting hole diameter | 4.5 mm | 3 – 8 |
| Center hub diameter | 40 mm | 20 – 80 |
| Center hub rise above face | 1.2 mm | 0.5 – 5 |
| Radial slot length | 35 mm | 20 – 60 |
| Slot width at outer end | 9 mm | 5 – 20 |
| Hub-to-slot clearance | 2 mm | 1 – 5 |
| Slot-to-ring clearance | 1.5 mm | 0.5 – 5 |
| Hub hex hole diameter across vertices | 6 mm | 3 – 12 |
| Hub hex hole edge margin | 1.5 mm | 0.8 – 4 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →UAV Ogive Nose Cone
Design a watertight, 3D-printable aerodynamic nose cone module for a fixed-wing tactical UAV, optimized for printing in Carbon Fiber Filled PETG (PETG-CF). The base of the nose con
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w
Flat-Strap Reel Spool
Create a 3D model of a custom flat-strap reel spool for a home plate housing cavity. Geometry: - A reel spool consisting of two parallel circular outer flanges connected by a cent
PET Recycling Kiosk Frame
Design a production-ready welded steel frame for an outdoor PET bottle recycling and animal feeding kiosk. Create ONLY the steel frame. Do not create covers, motors, tanks, electr
JZX100 Gas Cap Holder
can you make a gas cap holder for a jzx100 chaser. i want you to refer to the image and make a cad very close to the picture
Compression Testing Tower
The central square tower contains a 450 mm lead screw and a parallel 16 mm diameter steel guide shaft. Both are securely supported by bearings. A horizontal sliding block spans be
