Gears and transmission
X config quadcopter concept
- Bounding box
- 733.1 × 733.1 × 274 mm
- Engine
- Robotics B-rep
- Parameters
- 10
- Published
- October 29, 2026
Download
Free to download and use. See the terms.
The prompt
Visualize a quadcopter drone, X configuration, as a clean 3D model for concept review only, not a final CAD part. A lightweight, solid aluminum plate in the centre, octagon shaped, is the main structure. Four aluminum arm tubes bolt to the four diagonal faces of the plate, out to four motors at the corners, 650 mm motor to motor diagonal, 15 inch propellers. A battery hangs underneath the plate on a tray, with landing gear legs outside the battery. An octagon ABS case sits on top of the plate, not structural, with a flat front face. Inside the case, at the centre of the plate, is a small flight controller. A GPS mast sits on top of the case. Overall look: flat central plate, arms out diagonally, battery below, octagon case above, motors and propellers at the four corners.
Parameters
| Name | Value | Range |
|---|---|---|
| Landing gear / plate height | 120 mm | 80 – 200 |
| Centre plate thickness | 4 mm | 2 – 10 |
| Octagon plate circumradius | 90 mm | 60 – 140 |
| Motor-to-motor diagonal | 650 mm | 500 – 900 |
| Arm tube diameter | 16 mm | 10 – 25 |
| Propeller diameter | 381 mm | 254 – 508 |
| Battery tray drop below plate | 70 mm | 40 – 120 |
| ABS case height | 60 mm | 30 – 120 |
| ABS case octagon radius | 75 mm | 50 – 120 |
| GPS mast height | 80 mm | 40 – 150 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Spur Gearbox
design gearbox
Involute Spur Gear with Keyway
Precision Involute Spur Gear with Hub and Keyway: Module (m) of 2.0 mm, 40 teeth (z), Pitch Circle Diameter (d) of 80.00 mm, 20° pressure angle (\alpha), 15.00 mm face width (b), a
Parametric Helical Gear
Create a parametric helical gear with the following specifications: 32 teeth, normal module of 3 mm, right-hand helix, total face width of 80 mm, and a central bore hole with a dia
Rod with Spur Gear
Metal rod diameter is 20 mm and length is 100 mm and right side attach a gear and their OD is 50 mm
Spur Gear (12 Teeth)
Built a gear with 12 teeth
Two-Stage Spur Gear Reduction Assembly
Design a 2-stage spur gear reduction set for 3D printing with an overall 10:1 ratio. Stage 1: A 12-tooth pinion driving a 36-tooth gear (3:1). Stage 2: A 12-tooth pinion coupled