3D preview of Wheel Pointer Arrow
Loading the interactive model…
Interactive 3D model of Wheel Pointer Arrow

Brackets and mounts

Wheel Pointer Arrow

2 views
Bounding box
100 × 207.5 × 200 mm
Engine
3D Printing B-rep
Parameters
6
Published
November 22, 2026

Download

Free to download and use. See the terms.

The prompt

Design an arrow (pointer/stopper) which should add resistance to rotating wheel and eventually stop it pointing to single section. Arrow sould be wall mounted. A steel shaft on a bearing will be used as a core for sturdiness (6mm diameter) cut to size. To make arrow go back to center by using spring mounted at the back Arrow should be approx 200mm tall from base to its tip and maximum 100mm at its widest part Tip should be made of TPE so that it absorbs when hit make arrow fully triangular (so that its widest point is at its base) should use this type of spring (second picture). wheel should be able to rotate both ways Available materials for printing: ABS, PETG and TPE

Parameters

NameValueRange
Total Height200 mm150 – 250
Base Width100 mm80 – 120
Shaft Diameter6 mm4 – 10
Wall thickness2 mm1.2 – 4
Length of TPE tip20 mm10 – 30
Depth of spring mounting bracket40 mm30 – 60

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.